UTAX (UK) Ltd. - CLP & Launch

Clp 3316 Driver

Hauptnavigation

Paper does not pass the duplex refeed sensor. Clean the main charger grid by using main charger grid cleaner. Do not touch the pins painted red. The toner remaining on the primary transfer belt is transferred onto the fur brush that is biased and continuously revolving.

Check if the contact between the upper and lower registration rollers is correct. Defective expanding memory.

Use only a small amount of solvent at a time, being careful not to spill. Detects the ambient humidity. Never substitute electric wires, as the printer may be seriously damaged. After secondary transferring is done, the toner which remains in the primary transfer belt is collected back in the waste toner box. Keep away from chains and belts.

All instances including those are not occurred are displayed. Check the fuser pressure springs. Replace the yellow developer unit. Check that the printer operates properly and then turn off the printer.

After removing or replacing the duplexer, do the operation check. After removing or replacing the paper feeder, do the operation check. Sensor value increases too few and does not increase proportionally. Malfunction of the engine firmware or defective engine firmware.

Print example Causes Defective developing sleeve bias output. Turn the dial so that the size of the loaded paper is indicated in the paper size indication window.

UTAX Windows 8 Printer Driver Downloads

Using a flat blade screwdriver, gv-nx44128te driver unlatch the right cover at the nine positions as shown in the diagram. Adhesion of soiling to primary transfer belt. The specific action required is shown inside the symbol.

Replace the cyan toner container. Update the engine firmware as needed.

Turn the lock lever backward to the lock position. Check if the pulleys, rollers and gears operate smoothly. Paper does not arrive at the duplexer refeed eject sensor.

Check if the main charger unit is properly seated. This may cause fire or electric shock. Purpose To allow machine malfunction analysis based on the frequency of paper misfeeds and self diagnostic. If the density of each color is not kept constant, the resultant color image will be deteriorated.

Clp 3316 driver

Flawed developing sleeve roller. Detects the timing of primary feeding.

Paper does not pass the registration sensor. Each portion of colors has three different magnitude of halftones bands. Symbols The triangle symbol indicates a warning including danger and caution. Insert the network interface card into the optional interface slot.

Worn primary transfer belt. Install the black toner container into the printer. If wearing loose clothing or accessories such as ties, make sure they are safely secured so they will not be caught in rotating sections. Insert the memory card into the memory card slot. Check if the paper is excessively curled.

Wipe spills off completely. Defective primary transfer cleaning unit. Turn the fuser unit bottom side up.

Shake the black toner container several times to loosen the toner inside. Since focusing in yellow is hardly readable, yellow is mixed with cyan for more readability, resulting in green.

Refit the connector cover. The specific prohibition is shown inside the symbol. Installing the drum unit, which is incompatible with the printer specification. Paper sent from the secondary transfer and separation section is applied with heat and pressure to permanently fuse toner on paper. Insert the memory card into the printer's memory card slot.

Use the two screws to secure the network interface card. Detects the ambient temperature.

The primary transfer belt is not in its proper position or the primary transfer unit is defective. Paper does not pass the duplexer refeed rear edge sensor.

Ask a Question

Defect fur brush of the primary transfer cleaning unit. Do not touch the drum surface with any object. Right edge of the top cover floating, it is not closed completely. Clean the main charger wire by using main charger wire cleaner. These substances ensure smooth paper travel as well as the durability of the belt itself.